Quantcast COLUMN ENTRIES - TM-5-6350-264-14-P-20049

 

Click here to make tpub.com your Home Page

Page Title: COLUMN ENTRIES
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
APPENDIX B MAINTENANCE ALLOCATION CHART - TM-5-6350-264-14-P-20048
Up
TM-5-6350-264-14-P-2 Transceiver Ultrasonic Motion Signal RT-1 161 / FSS-9(V) NSN
Next
Section II. MAINTENANCE ALLOCATION CHART - TM-5-6350-264-14-P-20050
TM 5-6350-264-14&P-2
NAVELEX EE181-AA-OMI-030/E121 RT1161 M9443
T.O. 31S9-2FSS9-1-2
listed  maintenance  function  varies  at  different
k. Rebuild.
Consists of those service/actions
maintenance levels, appropriate "work time" figures
necessary  for  the  restoration  of  unserviceable
will be shown for each level. The number of man-hours
equipment to a like new condition in accordance with
specified by the "work time" figure represents the
original manufacturing standards. Rebuild is the highest
average time required to restore an item (assembly,
degree of materiel maintenance applied to Army
subassembly, component, module, end item, or system)
equipment. The rebuild operation includes the act of
to a serviceable condition under typical field operating
returning to zero those age measurements (hours/miles,
conditions.  This  time  includes  preparation  time,
etc.)
considered
in
classifying
Army
troubleshooting time, and quality assurance/quality
equipments/components.
control time in addition to the time required to perform
B-3. COLUMN ENTRIES.
the specific tasks identified for the maintenance
functions authorized in the maintenance allocation chart.
The symbol designations for the various maintenance
a. Column 1, Group Number. Column 1 lists group
levels are as follows:
numbers,  the  purpose  of  which  is  to  identify
components, assemblies, subassemblies, and modules
C .....................
Operator or crew
with the next higher assembly.
O......................
Organization maintenance
b. Column 2, Component/Assembly. Column 2
contains  the  names  of  components,  assemblies,
F .....................
Direct support maintenance
subassemblies, and modules for which maintenance is
authorized.
H......................
General support maintenance
c. Column 3, Maintenance Function. Column 3 lists
D .....................
Depot maintenance
the functions to be performed on the item listed in
column 2.
e. Column 5, Tools and Equipment. Column 5
specifies, by code, those common tool sets (not
d. Column 4, Maintenance Level. Column 4
individual tools) and special tools, test, and support
specifies, by the listing of a "work time" figure in the
equipment required to perform the designated function.
appropriate  subcolumn  (s),  the  lowest  level  of
maintenance authorized to perform the function listed in
f. Column 6, Remarks. Column 6 contains an
column 3. This figure represents the active time
alphabetic code which leads to the remark in section IV.
required to perform the maintenance function at the
Remarks, which is pertinent to the item opposite the
indicated level of maintenance. If the number of
particular code.
complexity of the tasks within the
B-2

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business