APPENDIX B MAINTENANCE ALLOCATION CHART - TM-5-6350-264-14-P-20048

TM 5-6350-264-14&P-2

NAVELEX EE181-AA-OMI-030/E121 RT1161 M9443

T.O. 31S9-2FSS9-1-2

APPENDIX B

MAINTENANCE ALLOCATION CHART

Section I. INTRODUCTION

B-1 GENERAL

d. Adjust. To maintain, within prescribed limits, by

bringing into proper or exact position, or by setting the

operating characteristics to specified parameter.

a. This section provides a general explanation of

all maintenance and repair functions authorized

e. Align. To adjust specified variable elements of

at various maintenance levels.

an item to bring about optimum or desired performance.

b Section II designates overall responsibility for

the performance of maintenance functions on

f. Calibrate. To determine and cause corrections to

the identified end item or component. The

be made, or to be adjusted on instruments for test,

implementation of the maintenance functions

measuring and diagnostic equipments used in precision

upon the end item or component will be con-

measurement. Consists of comparisons of two

functions.

instruments, one of which is a certified standard of

c Section III lists the special tools and test

known accuracy, to detect and adjust any discrepancy in

equipment required for each maintenance

the accuracy of the instrument being compared.

function as referenced from section II.

d. Section IV contains supplemental instructions

g. Install. The act of emplacing, seating, or fixing

or explanatory notes for a particular

into position an item, part, or module in a manner to

maintenance function.

(Not Applicable) i.

allow the proper functioning of an equipment or system.

Repair. The application of maintenance f

B-2. MANTENANCE FUNCTIONS. Maintenance

h. Replace. The act of substituting a serviceable

functions are defined as follows:

like part, subassembly, or module for an unservicable

counterpart

a. Inspect. To determine the serviceability of an

item by comparing its physical, mechanical and/or

i. Repair. The application of maintenance services

electrical characteristics and/or electrical characteristics

(inspect, test, service, adjust, align, calibrate, or replace)

with established standards through examination.

or other maintenance actions (welding, grinding,

riveting, straightening, facing, remachining, or

b. Test. To verify serviceability and detect incipient

resurfacing) to restore serviceability to an item by

failure by measuring the mechanical or electrical

correcting specific damage, fault, malfunction, or failure

characteristics of an item and comparing those

in a part, subassembly, module, end item or system

characteristics with prescribed standards.

j. Overhaul. That maintenance effort (service/

c. Service. Operations required periodically to

actions) necessary to restore an item to a completely

keep an item in proper operating condition, i.e., to clean,

serviceable/operational condition as prescribed by

to preserve, to drain, to paint, or to replenish fuel,

maintenance standards (i.e., DMWR) in appropriate

lubricants, hydraulic fluids, or compressed air supplies.

technical publications. Overhaul is normally the highest

degree of maintenance performed by the Army.

Overhaul does not normally return an item to like new

condition.

B-1