Lampholder XDSI Removal and Replacement.

TM 32-6110-003-24&P

p. Lampholder XDSI Removal and Replacement. Refer to figure 5-3 and proceed as follows:

(1) Remove the bottom cover (3) in accordance with paragraph 5-10a.

(2) Pull heatshrink tubing away from lampholder (40) terminals, tag and unsolder wires from lampholder

(40).

(3) Remove nut (41) and washer (42) that secure lampholder (40) to front panel (16) and remove

lampholder (40) from chassis.

(4) To replace lampholder (40), insert lampholder through opening in front panel (16) and secure with nut

(41) and washer (42).

(5) Solder wires as marked during removal. Slide heatshrink tubing (item 10, App. D) over connections

and remove tags from wires.

(6) Install bottom cover (3) in accordance with paragraph 5-11c.

(7) Refer to section V of this chapter.

q. Handle Removal and Replacement. Refer to figure 5-3 and proceed as follows:

(1) Remove top cover (2) and bottom cover (3) in accordance with paragraph 5-10a.

NOTE

It may be necessary to remove circuit breaker CB8 in order to obtain access to

attaching parts for handle. (Refer to paragraph

(2) Remove two screws (48), lock washers (49), and flat washers (50) that secure handle (51) to front

panel (16).

(3) To replace handle (51), secure to front panel (16) with two screws (48), lock washers (49), and flat

washers (50).

(4) Install top cover (2) and bottom cover (3) in accordance with paragraph 5-11c.

r. Front Panel Removal and Replacement. Refer to figure 5-3 and proceed as follows:

(1) Remove top cover (2) and bottom cover (3) in accordance with paragraph 5-10a.

5-32