 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM
9-2350-238-20-2
NOTE
Remove tube reducer (17) and preformed
8
packing
(18).
Gain access to traversing system
solenoid valves hydraulic lines and
fittings through well.
The
vehicle
hydraulic
system
is
of
Make sure MASTER switch is OFF
the open center type and has
before removing electrical leads.
Failure to observe this warning could
pressure only when the hydraulic
result in injury to personnel.
pumps are operating.
Two level wind traverse directional
Tag
and
disconnect
two
electrical
leads
9
control solenoid valves are
(19) from two level wind traverse direc-
mounted on left turret wall.
tional control solenoid valves (2 and 11).
(20), six
Remove
six
hexagon
capscrews
Disconnect traverse motor control line
10
1
Iockwashers (21), and two level wind
tube assembly (1) from level wind traverse
traverse directional control solenoid
directional control solenoid valve (2).
valves (2 and 11).
2
Disconnect solenoid valve motor control
11
Back off tube fitting locknut (22) on tube
metal tube assembly (3) from level wind
to boss tee (15) and remove level wind
traverse directional control solenoid valve
(2).
traverse
directional
control
solenoid
valve
(2).
Remove
external
thread
tube
reducer
(4),
3
Remove tube to boss tee (15), preformed
12
preformed packing (5), tube elbow (6),
tube fitting locknut (7), flat washer (8),
packing (23), tube nipple (24), tube fit-
ting locknut (25), flat washer (26), and
and preformed packing (9) from level wind
preformed
packing
(27).
traverse
directional
control
solenoid
valve
(2).
13
Remove
preformed
packing
(28),
flat
Disconnect solenoid valve to motor input
washer (29), and tube fitting locknut
4
metal tube assembly (10) from level wind
(22) from tube to boss tee (15).
traverse
directional
control
solenoid
valve
Disconnect level wind solenoid valve
(11).
14
pressure line to tee metal tube assembly
Remove tube reducer (12) and preformed
(30) and tube assembly (31) from tube
5
tee (32).
packing (13).
Remove
tube
tee
(32),
tube
fitting
15
Disconnect level wind solenoid valve input
6
locknut (33), packing retainer
(34),
and
pressure
line
nonmetallic
hose
assembly
preformed packing (35).
(14) from tube to boss tee (15).
Disconnect traverse motor control line
7
metal tube assembly (16) from level wind
traverse
directional
control
solenoid
valve
(11).
2-203
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals