|
|
TM 9-2350-238-20-1
28
Install hook bolt (1) in eye (48) and tighten
turnbuckle body (2).
29
Set HYD PUMP/PTO CLUTCH switch (46)
to OFF.
30
Turn off engine.
2-171. MAINTENANCE OF SPADE HYDRAULIC CONTROL VALVES, LINES, AND
FITTINGS.
This task covers:
a. Removal
b. Inspection/Repair
c. Installation
INITIAL SETUP
Materials/Parts
Lockwasher (10)
Preformed packing (4)
Preformed packing (5)
Preformed packing (8)
Tube fitting locknut (11)
Tube fitting locknut (4)
References
TM 9-2350-238-24P-1
General Safety Instructions
To avoid injury to personnel, do not tighten or loosen hydraulic fittings when
system is pressurized.
Lower the boom to stowed position before doing any maintenance on hydraulic
system.
Wipe up any spilled hydraulic fluid to prevent injury to personnel.
2-979
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |