|
|
TM 9-2350-238-20-1
To gain access to lockout cylinder assem-
10
bly, refer to page 2-831.
Using sling, support lockout cylinder
11
assembly (7).
12
Remove two cotter pins (8).
Remove straight headless pin (9), using
13
puller.
Using sling, remove lockout cylinder
assembly (7) from roadwheel lever (10).
Install two threaded straight pins into
15
opposing capscrew holes.
Install three hexagon head capscrews into
16
capscrew holes.
17
Screw puller adapter into pivot arm
assembly (3).
18
Screw slide puller into puller adapter.
Tighten three hexagon head capscrews
19
evenly. At the same time, using slide
puller, withdraw pivot arm assembly (4)
about 5.0 in. (12.7 cm) from hull.
Support pivot arm assembly (4).
20
Remove slide puller and puller adapter.
21
Remove three hexagon head capscrews.
22
Remove pivot arm assembly (4).
23
Remove threaded straight pins.
Lift roadwheel lever (10), and remove from
hull.
2-857
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |