|
|
TM 9-2350-238-20-1
5 Remove headless straight pin (5), using
hammer puller.
6 Remove lockout cylinder assembly (3)
from roadwheel lever (6).
7
Install two threaded straight pins into opposing capscrew holes.
Install three hexagon head capscrews.
8
9
Screw puller adapter into roadwheel pivot arm assembly (7).
Screw slide puller into puller adapter.
10
Tighten three hexagon head capscrews evenly. At the same time, using slide puller, withdraw
11
roadwheel pivot arm assembly (7) about 5 in. (13 cm) from hull.
Remove slide puller and puller adapter.
12
Remove three hexagon head capscrews.
13
Remove roadwheel pivot arm assembly (7).
14
Remove threaded straight pins.
15
NOTE
On some vehicles, the middle roadwheel on each side is equipped with a sleeve
spacer instead of a roadwheel lever.
Lift roadwheel lever (6) and remove from cavity in hull.
16
2-837
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |