|
|
TM 9-2350-238-20-1
Failure to remove or disconnect batteries before removing or installing any electrical
wiring harness or lead may result in injury or damaged equipment.
1 Wiring harnesses and leads are secured to the engine with loop clamps, straps, clips, ground
screws, etc. Remove only the hardware which secures the wiring harness or lead being
removed.
2 Tag and disconnect cable terminal (1) from starter.
3 Tag and disconnect cable terminal (2) from starter ground.
4 Remove starter to ground electrical lead (3) from engine.
1 Inspect for broken, damaged, or missing parts.
2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.
5 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).
1 Install starter to ground electrical lead (3) to engine.
2 Untag and connect cable terminal (2) to starter ground.
3 Untag and connect cable terminal (1) to starter.
4 Wiring harnesses and leads are secured to the engine with loop clamps, straps, clips, ground
screws, etc. During installation, make sure the wiring harness or lead is secure and all
hardware is tight.
2-747
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |