 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2350-238-20-1
3 For repair of cable terminals and shell
connectors, refer to general maintenance,
Failure to remove or disconnect
batteries before removing or installing
any electrical wiring harness or lead
4 Electrical wire and insulation sleeving are
may result in injury or damaged
manufactured items, refer to appendix D.
equipment.
5 Repair is by replacement of authorized
1
Wiring harnesses and leads are secured to
parts (TM 9-2350-238-24P-1).
the powerplant with loop clamps, straps,
clips, ground screws, etc. Remove only
the hardware which secures the wiring har-
ness or lead being removed.
For reassembly of wiring harness plug
Tag and disconnect shell connector (1)
2
connector, refer to general maintenance, page
from line connection.
Tag and disconnect two shell connectors
3
(2) from neutral position switch.
Tag and disconnect shell connector (3)
4
1
Install relay to starter and neutral position
from line connection.
switch branched wiring harness (9) to
powerplant.
Disconnect plug connector (4) from relay.
5
2
Untag and connect cable terminal (7) to
Tag and disconnect cable terminal (5) from
6
24-volt feed starter terminal (8).
starter coil (6).
Untag and connect cable terminal (5) to
3
Tag and disconnect cable terminal (7) from
7
starter coil (6).
24-volt feed starter terminal (8).
4
Connect plug connector (4) to relay.
Remove relay to starter and neutral
8
position switch branched wiring harness
Untag and connect shell connector (3) to
5
(9) from powerplant.
line connection.
6
Untag and connect two shell connectors
(2) to neutral position switch.
For disassembly of wiring harness plug
7
Untag and connect shell connector (1) to
connector, refer to general maintenance, page
line connection.
2-371.
Wiring harnesses and leads are secured to
8
the powerplant with loop clamps, straps,
ground screws, etc. During installation,
make sure the wiring harness or lead is
1 Inspect for broken, damaged, or missing
secure and ail hardware is tight.
parts.
2 If damaged or missing, replace marker
bands. Etch or stamp lead number on
new band.
2-725
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals