Installation - TM-9-2350-238-20-10745

TM 9-2350-238-20-1

2 Tag and disconnect plug connector (1)

5 If damaged, remove gasket (6) from

from rear bulkhead.

receptacle connector (5).

3 Tag and disconnect two shell connectors

6 Tag and disconnect plug connector (7)

(2) from circuit breakers.

from master relay.

4 Remove four screws (3), four washers (4),

7 Remove bulkhead to bulkhead starter

and receptacle connector (5) from front

circuit branched wiring harness (8) from

bulkhead disconnect to starter.

hull through driver's compartment.

For disassembly of wiring harness receptacle connector and plug connectors, refer to general

maintenance, page 2-371.

1 Inspect for broken, damaged, or missing parts.

2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3 For repair of shell connectors, refer to general maintenance, page 2-371.

4 Electrical wires are manufactured items, refer to appendix D.

5 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

For reassembly of wiring harness receptacle connector and plug connectors, refer to general

maintenance, page 2-371.

Install bulkhead to bulkhead starter circuit

Untag and connect two shell connectors

branched wiring harness (8) to hull through

(2) to circuit breakers.

driver's compartment.

Untag and connect plug connector (1) to

Untag and connect plug connector (7) to

rear bulkhead.

master relay.

Wiring harnesses and leads are secured to

If removed, install new gasket (6) to

the hull and components with loop clamps,

receptacle connector (5).

straps, clips, ground screws, etc. During

installation, make sure the wiring harness

Connect receptacle connector (5) to front

or lead is secure and all hardware is tight.

bulkhead disconnect to starter, and install

four washers (4) and four screws (3).

2-719