 |
|||
|
|
|||
|
Page Title:
MAINTENANCE OF BATTERY TO BULKHEAD DISCONNECT CABLE ASSEMBLY |
|
||
| ||||||||||
|
|
 TM 9-2350-238-20-1
5
Untag and connect plug connector (5) to
e. Untag and connect six shell
pressure switch.
connectors (12) to left headlight.
6
Untag and connect plug connector (6) to
f.
Untag and connect shell connector
right headlight.
(13) to forward air cleaner.
7
Untag and connect plug connector (7) to
g. Untag and connect two shell
dimmer switch.
connectors (14) to horn switch.
8
Connect 23 shell connectors at the
h. Untag and connect seven shell
following points:
connectors (15) to line connection.
a. Untag and connect two shell
9 Wiring harnesses and leads are secured to
connectors (8) to stoplight switch.
the hull and components with loop clamps,
straps, clips, ground screws, etc. During
b. Untag and connect shell connector (9)
installation, make sure the wiring harness
to suspension lockout system indicator
or lead is secure and all hardware is tight.
light.
c. Untag and connect three shell
connectors (10) to infrared and
blackout drive selector switch.
d. Untag and connect shell connector
(11) to panel light.
2-112. MAINTENANCE OF BATTERY TO BULKHEAD DISCONNECT CABLE
ASSEMBLY.
d. Reassembly
This task covers:
a. Removal
b. Disassembly
e. Installation
c. Inspection/Repair
INITIAL SETUP
Materials/Parts
General Safety Instructions
Electrical wire (figure D-2, appx D)
Gasket
Insulation sleeving (figure D-1, appx D)
Failure to remove or disconnect
References
batteries before removing or installing
TM 9-2350-238-24P-1
any electrical wiring harness or lead
may result in injury or damaged
equipment.
Equipment Conditions
2-918 Hull access cover removed
2-640 Battery access cover open and all
batteries removed
2-715
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals