MAINTENANCE OF LIGHTING SWITCH TO VEHICLE ACCESSORIES AND DISCONNECT BRANCHED WIRING HARNESS.

TM 9-2350-238-20-1

Install bulkhead disconnect to trailer receptacle disconnect, aft blower motor, and taillights

branched wiring harness (1) in hull.

Untag and connect five shell connectors (2) to trailer receptacle disconnect.

Untag and connect three shell connectors (3) to left taillight.

Untag and connect two shell connectors (4) to right taillight.

Connect plug connector (5) to bulkhead disconnect.

Untag and connect shell connector (6) to air cleaner blower motor.

7 Untag and connect two shell connectors (7) to line connections.

8 Install gasket (8) on receptacle connector (9).

9 Install receptacle connector (9) with gasket (8), four washers (10), and four socket head

capscrews (11) on bulkhead.

10 Connect plug connector (12) to receptacle connector (9).

11 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-111. MAINTENANCE OF LIGHTING SWITCH TO VEHICLE ACCESSORIES AND

DISCONNECT BRANCHED WIRING HARNESS.

a. Removal

d. Reassembly

This task covers:

b. Disassembly

e. Installation

c. Inspection/Repair

INITIAL SETUP

Materials/Parts

General Safety Instructions

WARNING

Failure to remove or disconnect

References

TM 9-2350-238-24P-1

batteries before removing or installing

any electrical wiring harness or lead

Equipment Conditions

may result in injury or damaged

2-640 Batteries disconnected

equipment.

2-952 Driver's seat removed

2-928 Driver's compartment forward

cowl removed

2-928 Driver's compartment aft cowl

removed

2-711