INSPECTION/REPAIR - TM-9-2350-238-20-10735

TM 9-2350-238-20-1

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. Remove only the hardware which secures the wiring harness or lead

which is being removed.

Disconnect plug connector (1) from receptacle connector (2).

Remove four socket head capscrews (3), four washers (4), receptacle connector (2), and gasket

(5) from bulkhead.

Remove gasket (5) from receptacle connector (2).

Tag and disconnect two shell connectors (6) from line connections.

Tag and disconnect shell connector (7) from air cleaner blower motor.

Disconnect plug connector (8) from bulkhead disconnect.

Tag and disconnect two shell connectors (9) from right taillight.

Tag and disconnect three shell connectors (10) from left taillight.

NOTE

Access to the remaining electrical leads is gained through the rear hull well.

Tag and disconnect five shell connectors (11) from trailer receptacle disconnect.

Remove bulkhead disconnect to trailer receptacle disconnect aft blower motor, and taillights

branched wiring harness (12) from hull.

DISASSEMBLY

For disassembly of wiring harness plug connector and receptacle connector, refer to general

maintenance, page 2-371.

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3 For repair of shell connectors, refer to general maintenance, page 2-371.

4 Electrical wire and rod are manufactured items, refer to appendix D.

5 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

2-709