|
|
TM 9-2350-238-20-1
Failure to remove or disconnect batteries before removing or installing any electrical
wiring harness or lead may result in injury or damaged equipment.
Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
1
clips, ground screws, etc. Remove only the hardware which secures the wiring harness or lead
being removed.
Tag and disconnect plug connector (1) from engine sending units connector.
2
Disconnect 19 shell connectors from instrument panel at the following points:
3
a. Tag and disconnect two shell connectors (2) from master switch panel light.
b. Tag and disconnect shell connector (3) from engine oil pressure gage.
c. Tag and disconnect shell connector (4) from engine coolant temperature indicator.
e. Tag and disconnect shell connector (6) from transmission oil pressure indicator.
f.
Tag and disconnect shell connector (7) from transmission oil temperature indicator.
g. Tag and disconnect two shell connectors (8) from high beam panel light.
h. Tag and disconnect shell connector (9) from fuel level indicator.
Tag and disconnect shell connector (10) from engine and transmission warning light.
i.
j. Tag and disconnect eight shell connectors (11) from 24-volt feed.
4
Remove disconnect to instrument panel branched wiring harness (12) from hull through driver's
compartment.
DISASSEMBLY
For disassembly of wiring harness plug connector, refer to general maintenance, page 2-371.
2-701
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |