|
|
TM 9-2350-238-20-1
Failure to remove or disconnect batteries before removing or installing any electrical
wiring harness or lead may result in injury or damaged equipment.
1 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. Remove only the hardware which secures the wiring harness or lead
which is being removed.
2 R e m o v e two screws (1) and circuit breaker (2) from bulkhead.
3 Tag and disconnect plug connector (3) from slip ring.
4 Tag and disconnect plug connector (4) from hull disconnect.
5 R e m o v e hull disconnect to slip ring lead and circuit breaker (5) from hull.
NOTE
Two screws and four washers are
supplied with circuit breaker; use care
not to lose them. If lost or damaged,
order a new circuit breaker.
Remove two screws (1), four washers (2),
1
and two cable terminals (3) from circuit
breaker (4).
2
For disassembly of wiring harness plug
connectors, refer to general maintenance,
2-687
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |