MAINTENANCE OF FLOOR DISCONNECT TO BULKHEAD DISCONNECT WIRING HARNESS

TM 9-2350-238-20-1

Install bulkhead disconnect to voltage regulator assembly wiring harness (1) in hull through

battery compartment.

Untag and connect shell connector (2) to generator charge indicator light line connection.

Untag and connect plug connector (3) to voltage regulator.

If removed, install new gasket (4) to bulkhead receptacle connector (5).

Untag and connect bulkhead receptacle connector (5) to bulkhead disconnect to generator field,

and install four washers (6) and four screws (7).

If removed, install new gasket (8) to bulkhead receptacle connector (9).

Untag and connect bulkhead receptacle connector (9) to bulkhead disconnect to generator

armature, and install four washers (10) and four screws (11).

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-99. MAINTENANCE OF FLOOR DISCONNECT TO BULKHEAD DISCONNECT WIRING

HARNESS.

This task covers:

a. R e m o v a l

d. Reassembly

b. Disassembly

e. Installation

c. Inspection/Repair

INITIAL SETUP

Materials/Parts

General Safety Instructions

Gasket (2)

Lockwasher (4)

Failure to remove or disconnect

batteries before removing or installing

References

TM 9-2350-238-24P-1

any electrical wiring harness or lead

may result in injury or damaged

equipment.

Equipment Conditions

2-640 Batteries disconnected

2-677