INSPECTION/REPAIR - TM-9-2350-238-20-10681

TM 9-2350-238-20-1

7 Tag and disconnect six shell connectors (14) from line connections.

8 Remove screw (15) and ground cable terminal (16) from bulkhead.

9 Tag and disconnect two shell connectors (17) from fuel pump switch (18).

10 Tag and disconnect two shell connectors (19) from pump and igniter switch (20).

11 Disconnect plug connector (21) from receptacle connector (22).

12 Remove four screws (23) and receptacle connector (22) from bulkhead.

13 Disconnect four shell connectors (24) at the following points:

a. Tag and disconnect shell connector from line connection.

b. Tag and disconnect shell connector from 15 AMP circuit breaker.

c. Tag and disconnect two shell connectors from driver's external engine and

XMSN warning light.

14 Disconnect plug connector (25) from receptacle connector (26).

15 Remove four screws (27) and receptacle connector (26) from bulkhead.

16 Remove bulkhead disconnect to driver's control branched wiring harness (28) from hull.

For disassembly of wiring harness plug connectors and receptacle connectors, refer to general

maintenance, page 2-371.

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3 For repair of cable terminals and shell connectors, refer to general maintenance, page 2-371.

4 Electrical wire and rod are manufactured items, refer to appendix D.

5 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

2-655