|
|
TM 9-2350-238-20-1
Failure to remove or disconnect batteries before removing or installing any electrical
wiring harness or lead may result in injury or damaged equipment.
1 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. Remove only the hardware which secures the wiring harness or lead
which is being removed.
2 Tag and disconnect plug connector (1) from receptacle connector (2).
3 Tag and disconnect shell connector (3) from 15 AMP circuit breaker (4).
4 Tag and disconnect plug connector (5) from fan (6).
5 Remove screw (7) and ground cable terminal (8) from bulkhead.
6 Disconnect five shell connectors (9) from driver's instrument panel (10) at the following points:
a. Tag and disconnect shell connector from line connection.
b. Tag and disconnect shell connectors from starter switch (11).
c. Tag and disconnect shell connector from instrument switch (12).
d. Tag and disconnect shell connector from master switch (13).
2-653
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |