|
|
TM 9-2350-238-20-1
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 2.
Disconnect lead 415 from circuit breaker connector (behind driver's seat).
Place red probe in circuit breaker connector. Ground black probe. Set
MASTER switch ON. If multimeter indicates about 24 volts, repair lead 415
between circuit breaker connector and circuit breaker. Refer to page 2-371.
If multimeter indicates no voltage, go to step 3. Set MASTER switch OFF.
Connect lead.
Step 3.
Disconnect circuit breaker connector from circuit breaker. Place red probe
in circuit breaker. Ground black probe. Set MASTER switch ON. If mul-
timeter indicates about 24 volts, replace circuit breaker connector. Refer to
switch OFF. Connect lead.
2-367
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |