|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Step 2.
Remove lead 10 from circuit breaker. Connect multimeter to circuit breaker
receptacles. If multimeter indicates 0 ohms, go to step 3. If multimeter
indicates infinity, replace circuit breaker. Refer to page 2-584. Connect
leads.
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 3.
Disconnect lead 71 from windshield wiper switch. Place red probe in lead
71. Ground black probe. Set MASTER switch ON. If multimeter indicates
about 24 volts, go to step 4. If multimeter indicates no voltage, repair lead
71 between 15A circuit breaker and windshield wiper switch. Refer to page
2-346
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |