 |
|||
|
|
|||
|
Page Title:
DRIVER'S HEATER CIRCUIT. (Cont) |
|
||
| ||||||||||
|
|
 TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 2.
Place red probe on pin C (lead 401). Ground black probe. Set MASTER
switch ON. Set START-OFF-RUN switch to START. If multimeter indicates
about 24 volts, go to step 3. If multimeter indicates no voltage, replace
driver's heater control box. Refer to page 2-1029. Set MASTER switch
OFF. Set START-OFF-RUN switch OFF. Connect wiring harness.
2-340
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals