|
|
TM 9-2350-238-20-1
BH. DRIVER'S HEATER FUEL PUMP CIRCUIT.
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 1.
Disconnect wiring harness from driver's heater control box. Place red probe
on pin A (lead 402 R). Ground black probe. Set MASTER switch ON. Set
START-OFF-RUN switch to START. If multimeter indicates about 24 volts,
go to step 2. If multimeter indicates no voltage, replace driver's heater
control box. Refer to page 2-1029. Set MASTER switch OFF. Set START-
OFF-RUN switch OFF. Connect wiring harness.
2-335
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |