|
|
TM 9-2350-238-20-1
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
To access wiring harness, remove hull engine compartment deck assembly
Step 9.
lid. Refer to page 2-935. Disconnect wiring harness. Place red probe in
socket C (lead 344). Ground black probe. Set MASTER switch ON. Set
AIR INTAKE FAN switch ON. If multimeter indicates about 24 volts, go to
step 10. If multimeter indicates no voltage, repair lead 344 between AIR
INTAKE FAN switch and wiring harness disconnect. Refer to page 2-1053.
Set MASTER switch OFF. Set AIR INTAKE FAN switch OFF. Connect
wiring harness.
2-321
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |