|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 13. Disconnect lead 403A from fuel filter heater switch. Place red probe in lead
403A. Ground black probe. Set MASTER switch ON. Set fuel filter heater
switch ON. If multimeter indicates about 24 volts, go to step 14. If multim-
eter indicates no voltage, replace fuel filter heater switch. Refer to page
nect lead.
2-312
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |