|
|
TM 9-2350-238-20-1
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Disconnect line disconnect (lead 317A) behind driver's instrument (switch)
Step 4.
panel. Place red probe in lead 317A. Ground black probe. Set MASTER
switch ON. Set HYD PUMP/PTO CLUTCH switch ON. If multimeter
indicates about 24 volts, repair lead 317A between line disconnect and
engine disconnect. Refer to page 2-371. If multimeter indicates no voltage,
repair lead 317A between line disconnect and HYD PUMP/PTO CLUTCH
switch. Refer to page 2-371. Set MASTER switch OFF. Set HYD PUMP/
PTO CLUTCH switch OFF. Connect lead.
2-291
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |