|
|
TM 9-2350-238-20-1
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 4.
To access electrical accessories panel, remove left C02 cylinder access
cover. Refer to page 2-923. Disconnect lead 37A from circuit breaker.
Place red probe in circuit breaker receptacle. Ground black probe. Set
MASTER switch ON. If multimeter indicates about 24 volts, go to step 5. If
multimeter indicates no voltage, replace circuit breaker. Refer to page
2-277
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |