|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Set MASTER switch OFF. Disconnect connector from vehicular light switch.
Step 1.
Place red probe on pin F of vehicular light switch. Place black probe on pin
D. If multimeter indicates 0 ohms, go to step 2. If multimeter indicates
infinity, replace vehicular light switch. Refer to page 2-566. Connect
connector to vehicular light switch.
Make sure MASTER switch is OFF before repairing electrical
circuits. Failure to observe this warning could result in injury to
personnel.
Disconnect lead 19 from BO-IR switch. Place red probe in BO-IR switch
Step 2.
connector. Ground black probe. Set MASTER switch ON. If multimeter
indicates about 24 volts, repair lead 19. Refer to page 2-371. If multimeter
indicates no voltage, go to step 3. Set MASTER switch OFF. Connect
lead.
2-246
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |