|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Place red probe on pin C of vehicular light switch. Place black probe on pin
Step 5.
K. If multimeter indicates 0 ohms, go to step 6. If multimeter indicates
infinity, replace vehicular light switch. Refer to page 2-566. Connect
connector to vehicular light switch.
Step 6.
Set MASTER switch ON. Turn vehicular light switch to STOPLIGHT. Apply
brakes. If stoplight does not operate, go to step 7. If stoplight is operating,
repair lead 22 from bulkhead disconnect to vehicular light switch. Refer to
2-230
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |