|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Make sure MASTER switch is OFF before repairing electrical
circuits. Failure to observe this warning could result in injury to
personnel.
To access engine disconnect, remove transmission deck lid assembly.
Step 6.
Refer to page 2-938. Disconnect wiring harness at engine disconnect.
Place red probe in socket N (lead 509). Ground black probe. Set MASTER
switch ON. Set INST switch ON. If multimeter indicates about 24 volts,
system is operating normally. If multimeter indicates no voltage, repair lead
509 from engine disconnect to warning switches. Refer to page 2-371. Set
MASTER switch OFF. Set INST switch OFF. Connect wiring harness.
2-198
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |