|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Disconnect lead GND from SUSPENSION LOCKED warning light.
Step 2.
Connect multimeter between lead GND (terminal end) and ground. If
multimeter indicates continuity, go to step 3. If multimeter indicates no
continuity, repair lead GND. Refer to page 2-371. Connect lead GND to
SUSPENSION LOCKED warning light.
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Disconnect lead 234 from SUSPENSION LOCKED warning light. Place
Step 3.
red probe in lead 234 (terminal end) and ground black probe. Set
MASTER switch ON. If multimeter indicates about 24 volts, replace
SUSPENSION LOCKED warning light assembly. Refer to page 2-571. If
multimeter indicates no voltage, repair lead 234 between SUSPENSION
LOCKED warning light and suspension lockout pressure switch. Refer to
SUSPENSION LOCKED warning light.
2-176
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |