|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Step 5.
To access bulkhead disconnect, remove driver's seat, refer to page 2-952;
and remove driver's compartment aft cowl, refer to page 2-928. Discon-
nect wiring harness at bulkhead disconnect. Place red probe on pin B
(lead 28) of receptacle. Ground black probe. If multimeter does not
indicate about 30 ohms, go to step 6. If multimeter indicates about 30
ohms, go to step 8. Connect wiring harness at bulkhead disconnect.
Step 6.
To access disconnect near magnetic clutch, remove fan well deck grille.
Refer to page 2-928. Disconnect wiring harness at disconnect near
magnetic clutch. Place red probe on pin B (lead 28) of plug. Ground
black probe. If multimeter indicates about 30 ohms, go to step 7. If
multimeter does not indicate about 30 ohms, repair lead 28 between
disconnect and fuel level transmitter, refer to page 2-371; and install fuel
level transmitter, refer to page 2-626. Connect wiring harness at
disconnect.
2-168
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |