|
|
TM 9-2350-238-20-1
2-10. TOOLS AND SUPPLIES (CONT).
Table 2-2. PREVENTIVE MAINTENANCE CHECKS AND SERVICES WITH LUBRICATION
INSTRUCTIONS FOR M578 RECOVERY VEHICLE (CONT)
Interval
Item To Check/
Procedure
Item
Not Fully Mission
Service
No.
Capable If:
Brakes
Drive vehicle at 15 to 20 mph (24 to 32 km/h), re-
Brake will not
28
S
lease accelerator pedal, and apply brakes. Vehicle
stop the vehicle,
should stop smoothly without pulling to either side.
brake pedal
Stop vehicle on a steep downgrade of solid ground
goes to the floor.
or pavement. Set parking brake and shift transmis-
Brake will not
sion to neutral. Brake must hold vehicle in place.
hold vehicle.
Repeat with vehicle stopped on a steep upgrade.
Troubleshoot if required. Refer to page 2-43.
29
S
and Top
Do not allow engine to exceed 2450 rpm for
Speed
more than 2 or 3 seconds. Allowing engine
to exceed 2450 rpm for more than 2 or 3
seconds may damage engine.
Accelerate with full throttle through all forward ranges
Vehicle will not
to top speed (34.0 mph (54.7 km/h)). Engine gov-
accelerate to top
erned speed under load should reach, but not ex-
speed (34 mph).
teed, 2450 rpm. Listen for unusual noises that could
Engine governed
be from loose or damaged parts. If necessary, light-
speed under
en or repair parts.
load exceeds
2450 rpm. Any
unusual noises.
Torsion Bar
A
30
Plugs
Check if torsion bar plugs (1) are fully seated and
retaining screws (2) are in place. If necessary, tight-
en plugs and screws.
Repair or replace torn or damaged seat cushion.
A
Driver's and
31
Crew Seats
2-42
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |