 |
|||
|
|
|||
|
Page Title:
Mechanically adjust meter needle to zero position. |
|
||
| ||||||||||
|
|
 TM 9-2350-222 -20-1-2
USE OF AN/URM-105 OR ME-77 C/U MULTIMETER
(Continued)
METER
NEEDLE
(SHOWN OVER
BLACK ZERO
MARK ON
Mechanically adjust meter needle to zero position.
FAR LEFT SIDE
OF
SCALE)
Place
in position of use (upright or flat on
q
back).
Check that meter probes are not connected to a circuit.
q
Check that probe tips are not touching each other.
q
ADJUSTMENT
Turn adjustment screw until meter needle is over black
SCREW
q
zero mark on far left side of bottom scale.
Does meter needle mechanically adjust to black
zero mark?
Turn in
for repair.
4-34
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals