 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-202-14&P
in place of OE/HDO-10 lubricant for all temper-
NOTES:
ature ranges where OE/HDO-10 lubricant is
specified in the key.
WARNING
2.
Oil Can Points: Semiannually or as required,
Drycleaning solvent P-D-680 is
lubricate the following with OE/HDO: hand-
toxic and flammable. Always wear
brake levers and linkage, adjustable front sup-
protective goggles and gloves, and
port leg pivot points and handcrank, rear
use only in a well-ventilated area.
stabilizer pivot points and latches, cargo body
Avoid contact with skin, eyes, and
tailgate hinges and latches, and rack and tail-
clothes, and DO NOT breathe
gate assembly hinges and latches.
vapors. DO NOT use near open
flame or excessive heat.
3.
Adjustable Front Support Leg: Annually
1.
For prolonged operation of equipment in
remove, clean, inspect, pack with GAA, and
extreme cold (temperatures below -10F
install (para 4-51).
[23C]), remove lubricants prescribed in the
4.
Master Cylinder: Semiannually fill to within 1/4
KEY for temperatures above -10F (-23C).
inch (6.35 mm) of top with BFS.
Clean parts with drycleaning solvent (Item 14,
5.
Wheel Bearings: Annually remove, clean,
fied in the KEY for temperatures of 0F to -
inspect, pack with GAA, and install (para 4-43).
65F (18C to -54). If OEA lubricant is
Refer to TM 9-214.
required to meet the temperature changes pre-
scribed in the KEY, OEA lubricant is to be used
6.
Springs: Do not lubricate.
I-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals