 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-202-14&P
4-43.
HUB, BRAKEDRUM, AND WHEEL BEARINGS MAINTENANCE (CONTINUED).
5.
Install washer (10), nut (9), and retainer (8) on spindle (4).
6.
Perform wheel bearing adjustment (subpara f).
f.
WHEEL BEARING ADJUSTMENT
NOTE
If performing wheel bearing adjustment as part of troubleshooting when wheel
and tire assembly has not been removed, perform steps 1 through 12.
If performing wheel bearing adjustment as a follow-on to hub, brakedrum, and
wheel bearings maintenance, perform steps 5 through 12 only.
1.
Apply handbrakes (para 2-10). Chock wheel and tire assembly opposite the side being adjusted.
Raise vehicle at front and rear corners of side being maintained until wheel and tire assembly is clear
of ground. Support vehicle with suitable jackstand.
2.
Release handbrake on side being adjusted (para 2-10).
3.
Remove grease cap (1) from hub (2).
4.
Remove cotter pin (3) from spindle (4). Discard cotter pin.
4-88
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals