 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-202-14&P
4-35.1. SERVICE BRAKE MAINTENANCE (M101A1 AND M116A1) (CONTINUED).
WARNING
If one brakeshoe is being replaced, replace all brakeshoes on axle. Combination of
old brakeshoes with new brakeshoes will cause uneven braking. Accidents causing
serious injury or death to personnel or damage to equipment may result.
3.
Inspect brakeshoe linings for cracks or grease. Measure lining thickness. Lining thickness must be at
least 1/8 inch (3.18 mm). Replace brakeshoes if damaged, grease soaked, or worn.
4.
Inspect parking brake lever, strut, and brake guide for cracks or wear.
5.
Inspect all other removed components for cracks, breaks, distortion, corrosion, or other damage.
Replace any damaged components.
d.
ASSEMBLY
1.
Install two brake guide washers (23).
2.
Install brake guide (22) and four capscrews (21).
3.
Install brakeshoe (20), washer (19), and new clip (18).
4.
Install strut (17) and new clip (16).
5.
Install brakeshoe (15), washer (14), and new clip (13).
6.
Install brake lever (2), pin (12), washer (11), nut (10), and cap (9).
7.
Install two springs (8) and spring clips (7).
Change 2 4-60.3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals