Installation - TM-9-2320-386-100190

TM 9-2320-386-10

3-9. WHEELS AND TIRES (Contd)

(2)

Installation.

CAUTION

When installing stud nuts, ensure that curved (ball seat) surface

of nut is toward wheel to ensure proper seating. Failure to do this

may result in damage to wheel

NOTE

Nuts have left-hand threads on left wheel assembly and right-

hand threads on right wheel assembly. Studs and nuts are

stamped (L) left and (R) right.

Use jack handle as a prybar to raise wheel over wheel studs.

Do not remove wheel valve or counterweight if replacing wheel

assembly with spare tire. Notify your supervisor.

(a)

Remove spare wheel from spare wheel carrier and install

unserviceable wheel in carrier. Refer to task b.

(b) Lift wheel assembly (5) and position on wheel studs (7) and (8).

(c) Install and hand-tighten six wheel stud nuts (9) on wheel studs (7)

and (8).

(d) Lower wheel assembly (5) to ground. Refer to task c.

(e) Using wheel stud nut wrench, tighten wheel stud nuts (9)

alternately, in tightening sequence shown.

(f) Install elbow (10) and adapter (11) on hollow wheel stud (8).

(g) Connect tube (4) on adapter (11).

NOTE

Perform step h if wheel assembly is replaced with spare tire.

(h) Install cap (9) (Appendix B, Item 10) on hollow wheel stud (8).

(i) Install stone shield (12) on drive flange (6) and wheel assembly (5)

with two nuts (3), lockwashers (2), and screws (1).

NOTE

Have lockwasher replaced and stud nuts checked and tightened to

specified torque by maintenance personnel as soon as possible.

Return unserviceable wheel and tire assembly to maintenance

personnel for repair, replacement, or exchange.

(3)

Tire Gauging.

WARNING

Stand clear of tire while gauging and inflating. Injury or death to

personnel may result from wheel components if tire explodes.

(a)

Remove tire inflation gauge (20) and hose (15) assembly (Appendix B,

Item 4) from stowage compartment.

(b) Start at one corner of vehicle and gauge all tires. Apply tire gauge

air chuck (19) on wheel valve stem (18) and press down to read tire

pressure on gauge dial (17).

3-30

Change 1