 |
|||
|
|
|||
|
Page Title:
Table 2-2. Operator/Crew Preventive Maintenance Checks and Services (Contd). |
|
||
| ||||||||||
|
|
 TM 9-2320-386-10
Table 2-2. Operator/Crew Preventive Maintenance Checks and Services (Contd).
ITEM TO
NOT FULLY
ITEM
INTERVAL
CHECK/
PROCEDURE
MISSION
NO.
SERVICE
CAPABLE IF:
5
Before
Instru-
WARNING
(Contd) Operation
ments
If air pressure reading is below
(Contd)
(Contd)
60 psi (414 kPa), braking will
require excessive pedal force.
Shut down engine and check to
see what is wrong. Failure to
obtain correct air pressure may
result in injury or death to
personnel.
g. Air pressure gauge (1) 90-120 psi
g. Air pressure
(621-827 kPa).
gauge reads 60 psi
(414 kPa) or below.
h. Battery/gener-
2
1
3
green area.
ator gauge needle is
in red area.
i. Fuel gauge (3) indicates fuel
level.
6
Service
Operate service brakes (11) to determine
Service brakes do not
brakes
stopping ability. Check for pulling to
operate properly, or
one side, grabbing, or other abnormal
brake pedal goes
operation.
within two inches
of floorboard.
7
Trans-
a. Shift transmission through all
Transmission control
mission
driving ranges.
lever is stiff or binding.
b. Run engine for at least one
minute. Shift to FIRST and then to
REVERSE to clear hydraulic circuits of
air. Shift to NEUTRAL and allow
4
engine to idle (1000-1500 RPM). Open
access door (5) located in floor on
passenger side of personnel compartment
and remove dipstick (4) from filler
tube (6). If transmission temperature is
below 160F (71C), ensure dipstick (4)
shows fluid level is within COLD RUN
5
band (7). If fluid level is not within
COLD RUN band, add as necessary, or
notify unit maintenance to drain.
6
7
4
2-24
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals