Disassembly - TM-9-2320-360-20-21127

TM 9-2320-360-20-2

17-6. CABLE HOLD DOWN ASSEMBLY REPLACEMENT (CONT)

b. Disassembly

(1) Remove two spring pins (1), pivot (2), and

two spacers (3) from mount (4).

(2) Remove arm (5) from mount (4).

NOTE

Do step (3) only if bearing or grease

fitting falls inspection criteria.

(3) Remove bearing (6), lockring (7), and

grease fitting (8) from arm (5).

(4) Remove two screws (9), lockwashers (10),

and bar (11) from arm (5).

Discard

lockwashers.

(5) Remove hose (12) from elbow (13) and

tee (14).

(6) Remove elbow (13) and tee (14) from

spring cushions (15).

(7) Remove two jamnuts (16), nuts (17), and

spring cushions (15) from mount (4).

c. Cleaning/Inspection

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and

gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and

clothes, and don't breathe vapors. DO NOT use near open flame or excessive heat.

The flash point is 100-138 F (38-59 C). If you become dizzy while using cleaning

solvent, get fresh air immediately and medical aid. If contact with eyes is made,

wash your eyes with water and get medical aid immediately.

(1) Clean all metal parts with dry cleaning solvent.

(2) Inspect spring air cushions for signs of cracking, splitting, or rotting.

(3) Inspect bearing and grease fitting for cracks or damage.

(4) Replaced damaged parts.

17-10