 |
|||
|
|
|||
|
Page Title:
Driver's Side Rear Floor Mat Removal |
|
||
| ||||||||||
|
|
 TM 9-2320-360-20-2
16-33. FLOOR MATS REPLACEMENT (CONT)
c. Driver's Side Rear Floor Mat Removal
(1) Remove five screws (1) and guard (2)
from cab floor (3).
(2) Remove screw (4), lockwasher (5), and
belt bracket (6) from cab floor (3).
(3) Remove floor mat (7) from cab floor (3).
(4) Clean old adhesive from cab floor (3).
d. Driver's Side Rear Floor Mat Installation
WARNING
Adhesive causes Immediate bonding
on contact with eyes, skin, or
clothing and also gives off harmful
vapors. Wear protective goggles and
use In well-ventilated area.
If
adhesive gets in eyes, try to keep
eyes open: flush with water for 15
minutes and get Immediate medical
attention.
NOTE
Cab floor must be clean and dry
before applying adhesive.
Only apply adhesive to area on
cab floor to be covered by floor
mat.
Allow
adhesive
to
dry,
approximately 4 minutes, before
installing floor mat.
(1) Apply thin coat of adhesive to cab floor
(3).
NOTE
Floor mat is installed under wire
harness.
(2) Install floor mat (7) on cab floor (3 ).
(3) Install belt bracket (6) on cab floor (3) with
new lockwasher (5) and screw (4).
(4) Install guard (2) on cab floor (3) with five
screws (1).
16-130
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
