2320-01-318-9902 EIC:B5C, VOLUME NO. 2">
|
|
TM 9-2320-360-20-2
16-25. DOOR WINDOW/REGULATOR REPLACEMENT (CONT)
WARNING
Always wear eye protection and
protective clothing when handling
glass. Failure to comply may result
in injury to personnel.
(5) Prop window (3) with wooden block.
(6) Remove two locknuts (6) from channel (7)
on door (5). Discard locknuts.
(7) Push window (3) completely up and
remove channel (7) from door (5).
(8) Remove two screws (8) from channel (7).
(9) Lower window (3) to bottom of door (5).
(10) Remove window (3) and channel (9) from
door (5).
(11) Remove channel (9) and rubber seal ( 0)
1
from window (3).
b. Installation
NOTE
Flat side of regulator mounting
bracket must face inside of vehicle.
Angled comer of glass must be at
bottom. Channel must be mounted to
glass 1-1/2 in. (3.8 cm) from edge of
glass at angled comer.
(1) Install channel (1) and rubber seal (2) on
window (3).
(2) Install window (3) in bottom of door (4)
and channel (1).
(3) Push window (3) completely up.
(4) Install two screws (5) on channel (6).
(5) Install channel (6) in door (4).
(6) Lower window (3) to stop (7).
(7) Install two new locknuts (8) on channel
(6).
16-96 Change 1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |