Removal cont'd - TM-9-2320-360-20-20878

TM 9-2320-360-20-2

(13) Remove locknut (30) and screw (31) from no. 4

yoke (32). Discard locknut.

(14) Remove no. 4 yoke (32) from shaft no. 3 (29).

WARNING

Support

shaft

when

removing

hardware to prevent It from falling.

Failure to comply may result in

serious Injury.

(15)

Remove two locknuts (33), two screws (34) and

spacer (34.1) from carrier bearing (35) and

frame (18). Discard locknuts.

NOTE

Lift shaft no. 3 over shaft no. 4 and

crossmember between second and

third axles. Then lift over no. 2 axle

torque arm. Assembly can be passed

under fifth wheel and up between

ramps to assistant.

(16) Remove steering shaft no. 3 (28) from vehicle

with aid of assistant.

(16.1) Remove locknut (35.1) and screw (35.2) from

yoke (35.3). Discard locknut.

(16.2) Remove yoke (35.3) from gear reducer (35.4)

and remove shaft no. 4 (35.5) from vehicle.

(16.3) Remove locknut (35.6) and screw (35.7) from

yoke (35.8) on steering shaft no.

5 (40).

Discard locknut.

(16.4)

Remove yoke (35.8) from gear reducer (35.4).

Change 1 13-27