 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
13-4. NO. 1 AND NO. 4 AXLE TIE ROD END REPAIR (CONT)
NOTE
If distances are correct, go to step
(20). If distances are not correct,
continue with step (12).
No. 1 and no. 4 axles are adjusted
the same way.
No.
4 axle is
shown.
(12)
Remove castle nut (4) from tie rod end (5) on
one side of HET Tractor only.
(13)
Remove tie rod end (5) from steering arm (6).
(14)
Loosen locknut (7) and clamp (8) on tie rod end
(5).
NOTE
Lengthening no. 1 axle tie rod will
decrease front-side measurement.
Shortening no. 1 axle tie rod will
increase front-side measurement.
Lengthening no. 4 axle tie rod will
increase front-side measurement.
Shortening no. 4 axle tie rod will
decrease front-side measurement.
(15) Turn tie rod end (5) counterclockwise
to
lengthen or clockwise to shorten tie rod (9).
(16) Tighten locknut (7) and clamp (8) after adjusting
tie rod (9).
(17) Install tie rod end (5) on steering arm (6).
(18) Install castle nut (4) on tie rod end (5). Do not
tighten.
(19) Repeat steps (1) thru (11).
(20) Tighten castle nut (4) to 150-200 lb-ft (203-271
Nm).
(21) Continue tightening castle nut (4) until hole in tie
rod end (5) aligns with slots in castle nut (4).
(22) Install new cotter pin (10) through castle nut (4)
and tie rod end (5).
13-10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
