 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
13-3. STEERING COLUMN REPAIR
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Materials/Parts
Steering wheel removed (para 13-2).
Ties, Plastic, Cable (Item 34, Appendix C)
Locknuts (2) (Item 58, Appendix G)
Locknuts (2) (Item 65, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 54, Appendix F)
Locknuts (2) (Item 72, Appendix G)
Wrench, Torque, 0-175 Lb-Ft (Item 73,
Locknut (Item 56, Appendix G)
Wrench, Torque, 0-200 Lb-In (Item 72,
a. Removal
NOTE
Location of plastic cable ties should
be marked before removal.
(1) Remove plastic cable ties
(1)
from
connectors (2) as required.
(2) Disconnect 1-pin,
2-pin,
and
6-pin
connectors (2).
(2.1) Disconnect wire assembly ground clip
(2.1) from steering column (6).
(3) Remove two locknuts (3), screws (4), and
rubber pads (5) while supporting steering
column (6). Discard locknuts.
(4) Remove locknut (7), screw (8), steering
column (6), spring (9), and dust cap (10)
from upper shaft (11). Discard locknut (5)
Remove two locknuts (12), screws (13),
left steering column brace (14), and right
steering column brace (15) from dash
(16). Discard locknuts.
Change 2 13-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
