Adjustment codnt'd

TM 9-2320-360-20-2

9-2. TWO-SPEED SHIFT LINKAGE ADJUSTMENT/REPLACEMENT (CONT)

NOTE

Shift rod will lock in three positions:

(1) all the way in HIGH, (2) middle

NEUTRAL, and (3) all the way out

LOW.

(5) Position shift rod (6) in NEUTRAL detent.

HIGH

NEUTRAL

LOW

SETTING

approx. 9/16 In. (14 mm)

approx. 1-5/8 In. (41 mm)

approx. 2-3/4 In. (70 mm)

(6) Loosen jamnut (7).

NOTE

If cable was disconnected

from

transfer case, go to step (9).

(7) Remove cotter pin (8) from clevis pin (9).

Discard cotter pin.

(8) Remove clevis pin (9) from yoke (10) and

shift rod (6).

NOTE

Yoke must be threaded on cable 0.75

in. (1.9 cm) to ensure proper yoke to

cable engagement.

(9) Install clevis pin (9) in yoke (10) and shift

rod (6).

(10) Loosen two nuts (10.1) on shift cable'(5).

(11) Adjust shift cable (5) in or out to obtain full

travel of shift rod in HIGH and LOW range.

(11.1) Tighten two nuts (10.1) on shift cable (5).

(11.2) Shift transfer case shift lever (11) several

times into HIGH and LOW range.

(11.3) Remove clevis pin (9) from yoke (10) and

shift rod (6).

(11.4) Turn yoke (10) in or out to obtain equal

shift lever (11) to doghouse (11.1)

clearance in HIGH and LOW range.

9-6