Installation - TM-9-2320-360-20-20558

TM 9-2320-360-20-2

9-2. TWO-SPEED SHIFT LINKAGE ADJUSTMENT/REPLACEMENT (CONT)

b. Installation

(1) Route cable (2) past transmission

modulator (2.1) and transmission pan

(2.2) to transfer case (2.3).

NOTE

Yoke must be threaded on cable 0.75

in. (1.9 cm) to ensure proper yoke to

cable engagement.

(1.1) Thread lower yoke (1) on cable (2).

(2) Position upper end of cable (2) by hole in

cab floor (3).

(3) Feed cable (2) through hole in cab floor

(3).

(4) Slide grommet (4) onto cable (2).

(5) Install grommet (4) in hole in cab floor (3).

(6) Place jamnut (5), washers (6 and 7), and

jamnut (8) on cable (2).

(7) Position cable (2) in upper bracket (9).

NOTE

Threaded portion of cable should be

centered in cable bracket before

tightening jamnut.

(8) Secure cable (2) in bracket (9) with

jamnuts (5 and 8) and washers (6 and 7).

(9) Thread jamnut (10) onto cable (2).

NOTE

Cable adjustment is done on transfer

case end of cable. To ensure cable

has adequate threads on transfer

case end, thread yoke on cable 0.75

in. (1.9 cm).

(10) Install yoke (11) on cable (2).

(11) Install clevis pin (12) in yoke (11) and shift

lever (13).

(12) Install new cotter pin (14) in clevis pin

(12).

(13) Tighten jamnut (10) against yoke (11) on

cable (2).

9-4 Change 1