Bracket and Strap Installation

TM 9-2320-360-20-2

7-3. 12-VOLT (REAR) ALTERNATOR/BRACKET AND STRAP REPLACEMENT (CONT)

c. Bracket and Strap Installation

(1) Install alternator mounting bracket (1) on engine

block (2) with two new lockwashers (3) and

screws (4).

(2) Install adjusting strap bracket (5) on engine

block (2) with screw (6), new lockwasher (7),

and nut (8). Do not tighten.

(3) Install new lockwasher (9) and screw (10) on

adjusting strap bracket (5) and engine block (2).

Torque to 35-40 lb-ft (47-54 Nm).

(4) Tighten screw (6) to 35-40 lb-ft (47-54 Nm).

WARNING

Pipe thread sealing compound can

burn easily, can give off harmful

vapors, and is harmful to skin and

clothing. To avoid injury or death,

keep away from open fire and use In

well-ventilated area. If pipe thread

sealing compound gets on skin or

clothing, wash Immediately with soap

and water.

CAUTION

Use pipe thread sealing compound

sparingly only on pipe threads. Do

not apply compound to hose

connections. Damage to equipment

may result.

(5) Coat threads of tee (11) with pipe thread sealing

compound.

(6) Install tee (11) and side elbow (12) as one unit

on air compressor (13).

(7) Coat threads of elbow (14) with pipe thread

sealing compound.

(8) Install top elbow (14) in tee (11 ).

(9) Install hose no. 2096 (15) on side elbow (12).

(10) Install hose no. 2114 (16) on top elbow (14).

(11) Install adjusting strap (17) on bracket (5) with

screw (18), new lockwasher (19), and nut (20).

(12) Install nut (21) on adjusting strap (17).

7-8 Change 1