 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
(2) Remove locknut (4) from clamp (5).
Discard
locknut.
(3) Remove clamp (5) and exhaust pipe (6) from
turbocharger (7). Discard clamp.
(4) Remove two nuts (8), lockwashers (9), clamp
(10), and spacer (11) from muffler (3). Discard
clamp, spacer, lockwashers, and nuts.
WARNING
Support muffler when removing
spacer. Failure to comply may result
in Injury to personnel.
(5) Remove two nuts (12), lockwashers (13), clamp
(14), and spacer (15) from muffler (3). Discard
clamp, spacer, lockwashers, and nuts.
(6) Remove exhaust pipe (6) from muffler (3).
(7) Remove four nuts (16), ten washers (17), four
springs (18), two screws (19), and muffler mount
channel (20) from muffler support bracket (21).
b. Installation
NOTE
First nut should be tightened until
there is 1.5 in (3.6 cm) between
channel and bracket.
(1) Install muffler mount channel (1) on muffler
support bracket (2) with two screws (3), four
springs (4), ten washers (4.1) and four nuts
(4.2).
NOTE
Exhaust pipe is mounted on inside of
muffler.
(2) Install exhaust pipe (5) in muffler (6).
(3) Install new spacer (7) and new clamp (8) on
muffler mount channel (1) with two new
lockwashers (9) and new nuts (10).
(4) Install new spacer (11) and new clamp (12) on
muffler (6) with two new lockwashers (13) and
new nuts (14).
NOTE
Clamp should be installed with ends
facing away from HET Tractor.
(5) Install exhaust pipe (5) on turbocha rger (15) with
new clamp (16) and new locknut (17).
(6) Tighten four nuts (10 and 14).
Change 1 5-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
