 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
4-14. ETHER STARTING AID REPAIR
This task covers:
a. Removal
d.
Assembly
b. Disassembly
e.
Installation
c. Cleaning/Inspection
f.
Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts
Engine hood opened (TM 9-2320-360-10).
Compound, Sealing, Pipe Thread (Item 15,
Inner fender removed (left side only)
Solvent, Dry Cleaning (Item 31, Appendix C)
Ties, Cable, Plastic (Item 34, Appendix C)
Gasket (Item 32, Appendix G)
Lockwashers (4) (Item 101, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 54, Appendix F)
Lockwasher (Item 102, Appendix G)
Compressor Unit, Air (Item 3, Appendix F)
Goggles, Industrial (Item 14, Appendix F)
WARNING
Starting fluid is toxic and highly
flammable. Container Is pressurized.
Never heat container or discharge
starting fluid In confined areas or
near open flame. Failure to comply
may result In Injury to personnel. If
Injured, seek Immediate medical
attention.
a. Removal
NOTE
To service cylinder only, do steps (2)
and (3).
(1) Disconnect plug (1) from receptacle (2).
(2) Remove two wingnuts (3) and bracket (4)
from studs (5).
NOTE
Cap should be installed on valve
body whenever cylinder is not
installed.
(3) Remove cylinder (6) and gasket (7) from
valve (8) by turning counterclockwise.
Discard gasket.
(4) Remove two studs (5), nuts (9),
lockwashers (10), and bracket (11)from
firewall (12). Discard lockwashers.
4-62 Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
