REASSEMBLY (cont) - TM-9-2320-285-24-20625

TM 9-2320-285-24-2

4-4.

TRANSMISSION (CONT)

1. Oil Pump and Front Support Assembly (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

REASSEMBLY (cont)

Oil pump

a. Lockup valve

Install

and front

(19), lockup

support

valve spring

group

(13), and

valve stop

(18)

b. Pressure regu-

Install

lator valve

(17), pres-

ure regu-

lator spring

(12), and

valve stop

(16)

c. Internal snap

Install

Attach pressure regulator and

rings (14 and

lockup spring compressor as

15)

shown in step 3h. Place in-

ternal snap rings (14 and

15) onto compressor screws

before compressing lockup

valve spring (13) and

pressure regulator spring

(12). Compress springs and

install snap rings. Remove

compressor

WARNING

Do not strike hardened steel pieces with steel hammer. Metal chips could cause serious injury to your

eyes. Seek medical attention immediately if you get metal chips in your eyes. Always wear safety goggles

when hammering.

NOTE

If valve pin installer is not available for step 14d, drive in valve guide (9) to extend 1.16-1.20 inches

beyond finished surface.

4-144